Swiss Made 10Gbit LAN expansion for PIP and MXCS

UNIXET

PIP Option		MXCS Option

The UNIXET is MPL’s dual 10GbE interface expansion. The expansion is designed to be used in combination with the PIP4x and the MXCS platforms. Both Ethernet interfaces support all Ethernet speeds from 10Mb to 10Gb on the integrated RJ45 Connectors. On the PCB are populated a total of 4 dual color LED’s to show Link and Activity information’s of the Ethernet interfaces.

Additionally, the UNIXET has two µSERLED connectors for Pass-through of the µSERLED I2C Signals and injection of the Link and Activity signals into the µSERLED. The UNIXET also features a second PCIe104 Connector on the top layer to Pass-through the unused 8 Lanes of the PEG Port as well as the additional 4 single lane PCIe Ports and the Power Rails of the PCIe104 connector.

Rugged Gigabit Ethernet Controller (UNIGET)

UNIXET Highlights

Support all Ethernet speeds from 10Mb to 10Gb
Ethernet Interfaces on RJ45 Connectors
4 dual color LED’s for link/act information
µSERLED Pass-through
Link/act information injection into µSERLED
PCIe104 Pass-through
Over temperature shutdown to protect the Ethernet controllers against destructive heat
Powered from the PCIe104 connector

These features make the UNIXET Family ideally suited for any rugged industrial or defense network applications. Due to the low power consumption, robust and flexible design, the products are well suited for embedded systems even in extended temperature environments. The UNIXET makes it easy to set up a challenging network gateway with all flavors and can also be combined with our rugged Switch Family.
* Typically 10 years or more, 20+ years repair-ability (after first introduction)

UNIXET used in industrial environment

PIP40 with built in UNIXET

MXCS with built in UNIXET

Technical Features

Board Key Data
10 GBit Copper ports	2 x Marvell ACQ113 controller with Industrial Temperature Grade available on two 10GigE RJ45 connectors Supports: • Polarity correction • 10MbE, 100MbE, 1GbE, 2.5GbE, 5GbE and 10GbE
Jumbo Frame support	Up to 16k Byte
On-Board indications	LEDs for Act and Link for both Eth Ports and Power good LED External LED PCB as option
PCIe104 pass trough	Pass trough of all none used PCIe104 signals (x8)
Driver support	Windows 10 as well as LINUX 3.10 and higher
Boot option	UEFI and PXE
MAC Features
	LSO, RSS, DCA and header checksum Quality of Service (QoS) support IPv4/v6, IPv6/TCP, and IPv6/UDP checksum offload Internet Control Message Protocol (ICMP) Address Resolution Protocol (ARP) Multicast Domain Name System (mDNS) Transmission Control Protocol (TCP) Keepalives (KA)
Management Support
Features	Automatic polarity detection Automatic MDI/MDI-X detection 16 kB jumbo frame support IEEE 802.1q VLAN support ESD protected connectors
Power
Input Voltage	3.3 VDC over PCIe/104 connector
Power Consumption	Up to 3W per LAN port with a 10GbE link <8W maximum in total
Environment
Storage Temperature	-45°C to 85°C (-49°F to 185°F)
Operating Temperature	-20°C to 60°C (-4°F to 140°F) at full operation
Extended Temperature	Up to -40°C to 85°C (-40°F to 185°F)
Relative Humidity	5% to 95% none condensing
Board size
PCB form factor Length	121.2mm
Width	95.9mm
Height	~34mm (with MPL heat sink mounted, measured from top of PIP4x PCB)
Weight	(with MPL Heat sink) TBD
Standard Compliance
The UNIXET is designed to meet or even exceed the most common standard Particular references are:
EMC	EN 55022, EN 55024, EN 61000, MIL-STD-461E
Shock & Vibration	EN 60068
Environmental & Safety	EN 50155, MIL-STD-810-F, EN 60601, EN 60950
Approval List	CE, IEC 60945, IACS E10